What did you do to your Z today?

[Zed62]

Installed Polisport Nomad handguards.   Perfect fit.  I had to remove the bar end weights and will need to make some parts on my lathe to adapt them back on.  The grips are just a tiny bit tingly without them.  The handguards look nice and keep my fingertips from freezing on cold mornings.

[Moto.Maddox]

I finally measured and set my rider sag.  I used the motool SLACKER V4, and it was really straight forward.  It would have been even easier if I had a front wheel Chock, but I was still able to do everything I needed to without much issue.

My front suspension settings were already in the sweet spot, giving me 35mm of rider sag.  The Rear was way off from the factory at around 50mm of rider sag, so I did have to dial in some pre-load at the Rear.